Brother International PR-620 Users Manual - English - Page 194

Release the snap lock on the standard cap 2 frame down and then disengage the latch. Open the clamping frame. Also, open brim presser. 3 2 Lift up (flip) the sweat guard on the inside of 4 the cap, and then place the cap in the standard cap frame. Using both hands, hold both sides of the cap, and then align the edge of the lower frame with the base of the brim. 1 1 Snap lock released 2 Clamping frame opened 3 Brim presser Placing a sheet of stabilizer. 3 Placing a sheet of about 100 mm (4 inches) x 250 mm (10 inches) of stabilizer on top of the lower frame, place a cap in the frame. 1 Edge of the lower frame 2 Sweat guard 3 Base of the brim At the same time, align the centerline of the cap with the centerline of the sweat guard holder on the standard cap frame, and then slide the sweat guard under the sweat guard holder. 1 100 mm (4 inches) 2 250 mm (10 inches) 3 Stabilizer 1 Sweat guard holder 2 Centerline of sweat guard holder 3 Centerline of cap After arranging the brim, firmly push in the 5 cap as far as possible. 7 Using the Optional Cap Frame 177