HP Xw5000 hp workstation xw5000 Technical Reference (309233-001 10/02) - Page 18

Table 1-4 Power Consumption and Cooling All information in this section is based on primary power consumptions. The power consumption listed in the following table are valid for a typical configuration: • One processor • 1 GB memory • Two hard disk drives • DVD ROM drive • Floppy drive • Graphics card • One monitor Power Consumption for Power Saving Modes Input power consumptiona Typical operating mode Standby mode Hibernate mode a. Approximate values 230V/50Hz and 115V/60Hz 170W 93W < 10 W When you turn off your workstation with the power button on the front panel, the power consumption falls below 10W, but is not zero. To reach zero power consumption when the workstation is off, either unplug the workstation from the power outlet or use a power strip with a switch. For additional information on power-saving features, see your operating system documentation. Table 1-5 Graphics and I/O Slots Power Specificationsa Type of card Number of slots available Maximum power per card 12v (maximum current) 5v (maximum current) 3.3v (maximum current) -12v (maximum current) PCI 5 25W per slot 500m A per slot 5 A per slot 7.6 A per slot 100m A per slot AGP 1 50W 5.17A 2A 13.6A -- Combined See note 100W -- -- -- -- PCI and belowb AGP a. AGP Card Specification: 8x AGP Pro50. PCI Specification: PCI 2.2. b. If an AGP Pro 50 card is installed, the adjacent PCI slot must be kept vacant to allow for cooling.