HP Xw5000 hp workstation xw5000 Technical Reference (309233-001 10/02) - Page 50
Installing a Floppy Drive,
UPC - 613326803318
View all HP Xw5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
Figure 2-25 Installing a Floppy Drive To install a floppy drive: 1. Shut down the workstation and turn off the display. Disconnect all power cables and any LAN or telecommunications cables. 2. Remove the side cover and front bezel (page 29). 3. Remove the old floppy drive from the bay. 4. Insert the drive: a. While holding the drive release lever out, slide the drive into the chassis. b. Release the lever so the drive clicks into position. Inserting a Floppy Drive 5. Connect the power and data cables to the rear of the new drive (see Figure 2-23 on page 49). 6. Replace the bezel and front cover (page 31). 7. Reconnect all the power and telecommunications cables.
¹º¿·½ÀÀ¾ºÁ¸³²¸ÂÃÄÀ½¶¾ºÁ¸±½²·¿¸½º´ Ŷ¶Ã¿¿³²¾Ã¿
Öò½½ÄºÕ³¸È¾
ÂÆÇÈÉÊ˲±
µÁ
Installing a Floppy Drive
To install a floppy drive:
1. Shut down the workstation and turn off the display. Disconnect all power cables and
any LAN or telecommunications cables.
2. Remove the side cover and front bezel (page 29).
3. Remove the old floppy drive from the bay.
4. Insert the drive:
a.
While holding the drive release lever out, slide the drive into the chassis.
b.
Release the lever so the drive clicks into position.
Figure 2-25
Inserting a Floppy Drive
5. Connect the power and data cables to the rear of the new drive (see Figure 2-23 on
page 49).
6. Replace the bezel and front cover (page 31).
7. Reconnect all the power and telecommunications cables.
çͲ
¼¶Ó¶Å½¶²ºÀ¶²Ó¶Æ¶·
»Í²
ÖÓ¾Ú¶²ºÀ¶²Ú·¾Æ¶²¾»
ç
»