HP Z210 HP Z210 CMT Workstation Maintenance and Service Guide - Page 132
Solving diskette problems, Problem, Cause, Solution, Start, Explore, File>Properties>Tools
View all HP Z210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 132 highlights
Solving diskette problems Table 6-2 Diskette problems Problem Cause Diskette drive light stays on. Diskette is damaged. Solution 1. Right-click Start, select Explore, and then select a drive. 2. Select File>Properties>Tools. 3. Under Error-checking, select Check Now. Diskette is incorrectly inserted. Remove and reinsert diskette. Files on the diskette are damaged. Verify the program diskettes. Drive cable is not properly connected. Reconnect the power cable and verify that all four pins are connected. Drive not found. Cable is loose. Reseat the diskette drive data and power cables. Removable drive is not seated properly. Reseat the drive. Diskette drive cannot write to a diskette. Diskette is not formatted. Diskette is write-protected. Format the diskette. Use another diskette or remove the write protection. Writing to the wrong drive. Verify the drive letter in the path statement. There is not enough space on the diskette. Use another diskette. Diskette write-control is enabled. Use the Computer Setup (F10) Utility to verify the storage security feature disabled settings. Diskette is damaged. Replace the damaged disk. Cannot format diskette. Invalid media reported. When formatting a disk in MS-DOS, you might need to specify diskette capacity. For example, to format a 1.44-MB diskette, enter the following command at the MS-DOS prompt: FORMAT A: /F:1440 A problem has occurred with a disk transaction. The directory structure is bad, or there is a problem with a file. 1. Right-click Start, select Explore, and then select a drive. 2. Select File>Properties>Tools. 3. Under Error-checking, select Check Now. Diskette drive cannot read a diskette. Diskette is not formatted. Format the diskette. You are using the wrong Verify the type of drive that you are using and use the diskette type for the drive type. correct diskette type. You are reading the wrong drive. Verify the drive letter in the path statement. Diskette is damaged. Replace the diskette with a new one. 120 Chapter 6 Diagnostics and troubleshooting ENWW