HP Z210 HP Z210 CMT Workstation Maintenance and Service Guide - Page 94
Rear system fan assembly, Removing the rear system fan assembly
View all HP Z210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 94 highlights
Rear system fan assembly This section describes how to remove and install the rear system fan assembly. Removing the rear system fan assembly To remove the rear system fan assembly: 1. Disconnect power from the workstation (see Predisassembly procedures on page 62). 2. Remove the side access panel (see Removing the side access panel on page 65). 3. Disconnect the rear system fan assembly cable (1) from the system board as shown in the following figure. Figure 5-23 Disconnecting fan wires 4. Remove the four screws from the rear of the chassis (2), and then pull the fan assembly inward and then up (3) out of the chassis. Installing the rear system fan assembly To install the rear system fan assembly, reverse these steps. 82 Chapter 5 Replacing components ENWW