HP Z210 HP Z210 CMT Workstation Maintenance and Service Guide - Page 80
Bezel, Removing the front bezel, Front panel I/O device assembly
View all HP Z210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
Bezel This section describes how to remove and install the front chassis bezel. Removing the front bezel To remove the front bezel: 1. Remove the side access panel (see Removing the side access panel on page 65). 2. Lift the release tabs (1), and then rotate the front bezel off the chassis (2). Figure 5-6 Removing the front bezel Installing the front bezel To install the front bezel, align the tabs discussed in the previous section and rotate the bezel until it snaps in place. Front panel I/O device assembly This section describes how to remove and install a front panel I/O device assembly. Removing the front panel I/O device assembly To remove the front panel I/O device assembly: 1. Disconnect power from the workstation (see Predisassembly procedures on page 62 ). 2. Remove the side access panel (see Removing the side access panel on page 65). 68 Chapter 5 Replacing components ENWW