Ricoh SP C252SF Operating Instructions - Page 322

10. Troubleshooting Problem Solution Prints do not stack properly. • The paper being used may be damp. Use paper that has been stored properly. See page 57 "Supported Paper". • Select [Lvl.2: Medium] or [Lvl.3: Strong] in [Anti-Humidity Level] under [System Settings]. Note that if you select [Lvl. 2: Medium] or [Lvl.3: Strong], the first print takes longer than subsequent prints. • Pull up the appropriate stop fence (forward fence for A4/Letter, rear fence for Legal size prints). See page 19 "Guide to Components". The printed paper is curled. • Load the paper upside down in the paper tray. • If the paper curl is severe, retrieve prints from the output tray more frequently. • The paper being used may be damp. Use paper that has been stored properly. • Select [Lvl.1: Weak], [Lvl.2: Medium] or [Lvl.3: Strong] in [Anti-Humidity Level] under [System Settings]. Note that if you select [Lvl.2: Medium] or [Lvl.3: Strong], the first print takes longer than subsequent prints. • If you enable [Toner Saving] under [System Settings], printing is generally less dense. Printed envelopes come out creased. Check if the fusing unit levers are properly set. Lower the fusing unit levers. Other Printing Problems Problem The toner has run out and printing has stopped. Solution When the "Continue printing?" message appears on the control panel, pressing [Yes] allows you to print a few more pages, but the print quality of those pages may be lower. 320