Sony STR-DN1080 Help Guide Printable PDF - Page 142
If an error code appears
View all Sony STR-DN1080 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 142 highlights
To check error codes or warning messages received in [Auto Calibration], proceed with the following steps: If an error code appears Check the error and perform Auto Calibration again. 1 Select [Retry]. 2 Follow the instructions on the TV screen and then press to select [Start]. The measurement starts in a few seconds. The measurement process takes approximately 30 seconds. A test tone is output from each speaker in sequence. When the measurement ends, a beep sounds and the screen switches. 3 Select the item you want. Save: Saves the measurement results and exits the setting process. Retry: Performs the Auto Calibration again. Discard: Exits the setting process without saving the measurement results. 4 Save the measurement results. Select [Save] in step 3. 5 If the Speaker Relocation/Phantom Surround Back screen appears, select the setting you want by referring to "Calibrating speaker positioning (Speaker Relocation/Phantom Surround Back)." Skip to step 6 if the screen does not appear in the following cases: The set speaker pattern does not include surround back speakers but does include surround speakers, and [Surround Speaker Position] is set to [Front]. [In-Ceiling Speaker Mode] is set to [Front & Center] or [Front]. 6 Select the type of calibration you want by referring to "Selecting the Auto Calibration type (Calibration Type)." 7 When [Do you want to activate Calibration Matching?] appears on the screen, select [Yes] or [No]. Yes: Expands the sweet spot for the viewing position and allows you to enjoy more natural sound by trimming the wavefront for each pair of left/right speakers. No: The measurement results of the Auto Calibration function are applied directly. 8 Select [Finish].