Sony STR-DN1080 Help Guide Printable PDF - Page 144
Outputting a test tone from each speaker Test Tone
View all Sony STR-DN1080 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 144 highlights
1 Select [Setup] - [Speaker Settings] from the home menu. 2 Select [Calibration Type]. 3 Select the setting you want. Full Flat: Makes the measurement of frequency from each speaker flat. Engineer: Sets to "the Sony listening room standard" frequency characteristics. Front Reference: Adjusts the characteristics of all of the speakers to match the characteristics of the front speaker. Off Note This function does not work in the following cases: Headphones are connected. [Auto Calibration] has not been performed. [Bluetooth Mode] is set to [Transmitter]. [DSD Native] is set to [On] and DSD signals are being played back. [Pure Direct] is set to [On]. The receiver may play signals at a lower sampling frequency than the actual sampling frequency of the input signals, depending on the audio format. [157] Adjusting Settings Speaker Settings Outputting a test tone from each speaker (Test Tone) You can output a test tone from each speaker in sequence. 1 Select [Setup] - [Speaker Settings] from the home menu. 2 Select [Test Tone]. 3 Select the setting you want. Off Auto: The test tone is output from each speaker in sequence. Front L, Center, Front R, Surround R, Surround L, Sur Back L, Sur Back (*), Sur Back R, Height L, Height R, Subwoofer: You can select which speakers will output the test tone. * [Sur Back] appears when only one surround back speaker is connected. 4 Adjust the speaker level.