Sony STR-DN1080 Help Guide Printable PDF - Page 188

1 Select the input for which you want to check information. 2 Press DISPLAY MODE on the receiver repeatedly. Each time you press DISPLAY MODE, the display will change cyclically as follows: Index name of the input (*1) - Input you selected - Sound field currently applied (*2) - Volume level - Stream information (*3) When listening to FM radio Preset station name (*1) - Frequency - Sound field currently applied (*2) - Volume level When receiving RDS broadcasts (for European and Asia-Pacific models only) Program service name or preset station name (*1) - Frequency, band and preset number - Sound field currently applied (*2) - Volume level *1 Index name appears only when you have assigned one to the input or preset station. Index name does not appear if only blank spaces have been entered or it is same as the input name. *2 [PURE.DIRECT] appears on the display panel when the Pure Direct function is activated. *3 Stream information may not be displayed. Note Characters or marks in some languages may not be displayed. [227] Adjusting Settings Reverting to the factory default settings You can clear all memorized settings and restore the receiver to the factory default settings by the following procedure. This procedure can also be used to initialize the receiver before you use it for the first time. Be sure to use the buttons on the receiver to perform this operation. 1 Turn off the receiver. 2 Hold down (power) on the receiver for 5 seconds. [CLEARING] flashes on the display panel for a while, then changes to [CLEARED !]. Note It takes a few minutes for the memory to be cleared completely. Do not turn the receiver off until [CLEARED !] appears on the display panel.