Bernina Artista 730E User Guide - Page 15
Winding the Bobbin - parts
View all Bernina Artista 730E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Winding the Bobbin Winding the Bobbin turn power switch to «1» (on) place empty bobbin on spindle Threading the Bobbin place thread on spool pin attach appropriate spool disc - diameter of spool disc is disc size following the direction of the arrow take thread through the rear guide and around the pretension stud wrap the thread around the inner bobbin two or three times and cut off any excess thread on the thread cutter press the engaging lever against the bobbin • the bobbin winder works automatically • the motor stops automatically when the bobbin is full remove the bobbin Thread Cutter cut the thread on the thread cutter Winding the Bobbin While Sewing or Embroidering place thread spool on vertical spool then, following the direction of the arrow, take thread through the thread guide on head frame and around the pretension stud follow the instructions as described above for the next steps of winding the bobbin Bobbin Case A To Remove raise the needle turn power switch to «0» (off) open the bobbin cover grasp the latch of the bobbin case with right hand remove case Caution! Moving parts - To reduce risk of injury, switch to «0» (off) before servicing. Close bobbin cover. To Insert hold the bobbin case latch • the opening on the case should be at the top insert bobbin case so that it engages close the bobbin cover Bobbin Thread Cutter insert the bobbin case take the thread over cutter A and cut the thread Note: For normal sewing, the bobbin thread does not have to be brought up as the loose end is just the right length to start sewing. • to insert bobbin see page 14 The Sewing Computer - Operating Instructions 13