Bernina Artista 730E User Guide - Page 262

Message • Cannot dial, please check the phone line and then dial number. Note Check the settings in the Setup Program and try again. • The authentication for the provider failed. Please check the username and the password. Check the settings in the Setup Program and try again. • The communication with the provider was interrupted. Please try later or use another provider. Connecting problems. Enter another provider if possible or try again. • An unknown error occurred with the Modem. Please try again. Remove modem, then reconnect. • You cannot save or delete files on the myartista Portal. The myartista portal provides tips and news. • A problem occurred in communicating with the myartista Portal. Please try again. Try to connect to myartista portal again. Remove modem and reconnect in necessary. • Your sewing/embroidery computer has now reached the time limit, where in order to guarantee continuous satisfactory work, the following small tasks should be carried out. Remove thread and lint and remnants from beneath the stitch plate, as well as from the feed dog area. These instructions can be found on page 185 of the manual. This message appears at approx. 180'000 stitches. Press «OK» to close message after cleaning and oiling. Press «ESC» to temporarily «delete» the message. It will, however, reappear after restarting the sewing/embroidery computer. After «deleting» it three times by pressing «ESC», the message will not appear again before another approx. 180'000 stitches will have been stitched. • Your sewing/embroidery computer has now reached the time limit, where your BERNINA dealer will be pleased to give it a service check. Take the sewing/embroidery computer to the BERNINA dealer for servicing. This message appears at approx. 2'000'000 stitches. After servicing, the stitch counter is reset to «0» by the Bernina servicing staff. Press «ESC» to temporarily «delete» the message. It will, however, reappear after restarting the sewing/embroidery computer. After «deleting» it three times by pressing «ESC», the message will not appear again before another approx. 2'000'000 stitches will have been stitched (i.e. at 4'000'000 stitches). • You have opted for the possibility not to take your sewing/embroidery computer to your BERNINA dealer. This message will therefore only come on again after the next period of sewing/embroidering has been accomplished. Flawless functioning of the sewing/embroidery computer can not be guaranteed if the servicing is not carried out at the recommended regular intervals. • Main Motor failed. Please check hook system. Open bobbin cover. Remove lint and thread remnants and clean hook system. 258 Embroidery Support - Messages