Dell PowerConnect W-IAP92 Dell Instant 6.2.0.0-3.2.0.0 User Guide - Page 20
Disabling the Provisioning Wi-Fi Network, Assigning a Static IP
View all Dell PowerConnect W-IAP92 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Disabling the Provisioning Wi-Fi Network The provisioning network is enabled by default. Instant provides the option to disable the provisioning network in APBoot through console. Use this option when you do not want the default SSID instant to appear in your network. To disable the provisioning network: 1. Connect a terminal or PC/workstation running a terminal emulation program to the Console port on the W-IAP. 2. Configure the terminal or terminal emulation program to use the following communication settings. 3. Power on the W-IAP. You see an autoboot countdown prompt that allows you to interrupt the normal startup process and access APBoot. 4. Click Enter before the timer expires. The W-IAP goes into apboot mode through console. Table 2 - Terminal Communication Settings Baud Rate Data Bits Parity Stop Bits Flow Control 9600 8 None 1 None 5. In the apboot mode, use the following commands to disable the provisioning network: n apboot> factory_reset n apboot> setenv disable_prov_ssid 1 n apboot> saveenv n apboot> reset Assigning a Static IP To assign a static IP to a W-IAP using APBoot: 1. Connect a terminal or PC/workstation running a terminal emulation program to the Console port on the W-IAP. 2. Configure the terminal or terminal emulation program to use the following communication settings. 3. Power on the W-IAP. You see an autoboot countdown prompt that allows you to interrupt the normal startup process and access APBoot. 4. Click Enter before the timer expires. The W-IAP goes into apboot mode through console. 5. In the apboot mode, use the following commands to assign a static IP to a W-IAP. Hit to stop autoboot: 0 apboot> apboot> setenv ipaddr 10.1.1.1 apboot> setenv netmask 255.255.255.0 apboot> setenv gatewayip 10.1.1.254 apboot> save Saving Environment to Flash... Un-Protected 1 sectors .done Erased 1 sectors Writing Use the printenv command to view the configuration. apboot> printenv 20 | Initial Configuration Dell PowerConnect W-Series Instant Access Point 6.2.0.0-3.2.0.0 | User Guide