Dell PowerConnect W-IAP92 Dell Instant 6.2.0.0-3.2.0.0 User Guide - Page 241

l Errors (fps) Graph Figure 189 - Errors (fps) Graph To see the graphs for the 5 GHz band, click the 5 GHz link. For more information about the graphs in the instant access point view and for monitoring procedures, see Table 42. Table 42 - Dell W-Instant Access Point View - RF Trends Graphs and Monitoring Procedures Graph Name Utilization Description Monitoring Procedure The Utilization graph shows the radio utilization percentage of the access point for the last 15 minutes. To see an enlarged view, click the graph.The enlarged view provides Last, Minimum, Maximum, and Average radio utilization statistics for the W-IAP for the last 15 minutes. To see the exact utilization percent at a particular time, hover the cursor over the graph line. To monitor the utilization of the selected W-IAP for the last 15 minutes, 1. Log in to the Dell W-Series Instant UII. The Virtual Controller view appears. This is the default view. 2. In the Access Points tab, click the W-IAP for which you want to monitor the utilization. The W-IAP view appears. 3. Study the Utilization graph in the RF Trends pane. For example, the graph shows 84% W-IAP radio utilization for the 2.4 GHz band at 12:15 hours. NOTE: You can also click the rectangle icon under the Utilization column in the RF Dashboard pane to see the Utilization graph for the selected W-IAP. The rectangle icon is seen as follows: 2.4 GHz Frames The 2.4 GHz Frames graph shows the In and Out frame rate per second for the radio in 2.4 GHz band for the last 15 minutes. l Outgoing frames - Outgoing frame traffic is displayed in green. It is To monitor the In and Out frame rate per second for the radio in 2.4 GHz band, for the last 15 minutes, 1. Log in to the Dell W-Series Instant UI. The Virtual Controller view appears. This is the default Dell PowerConnect W-Series Instant Access Point 6.2.0.0-3.2.0.0 | User Guide 241 | Monitoring