Dell PowerConnect W-IAP92 Dell Instant 6.2.0.0-3.2.0.0 User Guide - Page 84
Converting Back to a W-IAP, Rebooting the W-IAP, Standalone AP, Convert Now, Maintenance, Reboot
View all Dell PowerConnect W-IAP92 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
Figure 58- Standalone AP Conversion 3. Select Standalone AP from the drop-down list. 4. Select the Access Point from the drop-down list. 5. Click Convert Now to complete the conversion. 6. After the conversion the Access Point specified in the Dell W-Series Instant UI operates in standalone mode. Converting Back to a W-IAP The reset button located on the rear of a W-IAP can be used to reset the W-IAP to factory default settings. If you have converted your W-IAP to a campus AP or a Remote AP, pressing the reset button converts it back to a W-IAP. To reset a W-IAP, follow the instructions below: 1. Power off the W-IAP. 2. Press and hold the reset button using a small, narrow object, such as a paperclip. 3. Power on the W-IAP without releasing the reset button. The power LED flashes within 5 seconds indicating that the reset is completed. 4. Release the reset button. The W-IAP then boots with the factory default settings. NOTE: All APs have a reset button, except W-IAP175P and W-IAP175AC. Contact Dell support for the backward conversion process on these W-IAPs. Rebooting the W-IAP If you encounter any problem with the W-IAPs, you can reboot all W-IAPs or selected W-IAPs in a network using the Dell W-Series Instant UI. To reboot a W-IAP: 1. Click the Maintenance link. The Maintenance window appears. 2. Click the Reboot tab. 84 | Managing W-IAPs Dell PowerConnect W-Series Instant Access Point 6.2.0.0-3.2.0.0 | User Guide