IBM 4230 User Guide - Page 142
Models 101, 1S2, and 4S3 Twinaxial Attachment, Attaching a Twinaxial Signal Cable to the Printer
View all IBM 4230 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 142 highlights
Models 101, 1S2, and 4S3 Twinaxial Attachment Supported computers include: System/36 Application System/400* (AS/400*) 5294 and 5394 Remote Control Units. Attaching a Twinaxial Signal Cable to the Printer To attach a twinaxial cable (not shipped with the printer), follow these steps: 1. Set the address. If your desired printer address is 0, go to Step 3 on page 2-4. If your desired printer address is not 0, see the following table for the valid values and follow Steps 1a on page 2-3 through 1g on page 2-4 to change the value. If you do not know what to assign for the printer address, check with your system operator. If Desired Address Is: 0 1 2 3 4 5 6 Shown when Setting Set: Printer Address: 000 Printer Address=0 001 Printer Address=1 002 Printer Address=2 003 Printer Address=3 004 Printer Address=4 005 Printer Address=5 006 Printer Address=6 2-2 User's Guide