IBM 4230 User Guide - Page 209

Printer Configuration You can print the current values for each parameter. Each parameter is shown with its corresponding value printed to the right. The category and parameter names are printed in the current Display Language used on the operator panel. The current custom set is noted at the top right column of the configuration printout. If you need to verify each custom set, the Operator Print Tests must be run for each custom set. The custom set must be changed in the | configuration menu before running each configuration printout. See | Figure 5-1 on page 5-10, Figure 5-2 on page 5-11, Figure 5-3 on | page 5-12, Figure 5-4 on page 5-13, Figure 5-5 on page 5-14, and | Figure 5-6 on page 5-15 for sample printouts. Printer configurations can be checked by entering the configuration menus. To print the printer configuration: 1. Enter the Operator Print Tests (see "General Test Instructions" on page 5-1). The printer displays OPERATOR PRINT TESTS Printer Demonstration 2. Press Scroll ↑ or Scroll ↓ until the printer displays OPERATOR PRINT TESTS Printer Configuration 3. Press Enter or Start to begin the test. The Ready indicator goes on and printing begins. The printout shows the current configuration. The configuration printout is complete when the Ready indicator goes off. 4. The printer returns to the Operator Print Tests menu automatically when the configuration printout is complete. Chapter 5. Tests 5-9