IBM 4230 User Guide - Page 269
Setting Up the 4230 Printer.
View all IBM 4230 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 269 highlights
Problem: Forms buckle, twist, jam, or paper holes tear 1: The right tractor is adjusted incorrectly. Solution: Move the right tractor to obtain the correct form width. The tractor pins should be in the center of the paper holes. See Chapter 1, "Setting Up the 4230 Printer" for help on adjusting the tractor tension. 2: The forms device is installed incorrectly. Solution: Check the forms device installation (see Chapter 1, "Setting Up the 4230 Printer"). 3: The printer is not at the edge of the table. Solution: Move the printer to the front edge of the table. 4: The forms tension (F1 only) is not set correctly. Solution: Check the forms tension adjustment. See Chapter 1, "Setting Up the 4230 Printer" for help on adjusting the forms tension. 5: The forms supply is not aligned with the printer. Solution: Reposition the forms supply so that the forms feed evenly. See the information on loading and unloading forms in Chapter 1, "Setting Up the 4230 Printer." 6: The forms are catching on the carton edge. Solution: Remove the uneven carton edges, or remove the forms from the carton. Note: As the forms reach the bottom of the box, this problem can occur more often. 7: The ribbon is twisted or folded. Solution: Check the ribbon for folds or twists. 8: The forms contain excessive moisture. Solution: Store the forms in a cool, dry place before using them, or store the forms in the printer area for 24 hours. Appendix B. Problems B-39