IBM 4230 User Guide - Page 55

Using the Printer Verification Test for the F1 Forms Device To run the printer verification test, follow these steps: 1. Turn the power On (|) if not already on. 2. Wait until the printer displays READY 3. Press Stop. The printer displays NOT READY and then on Models 101, 1S2, and 4S3 you may see 15 COMMUNICATIONS CHECK CHECK CABLE or on Models 201, 2S2, and 5S3 you may see 28 COMMUNICATIONS CHECK CALL SYSTEM OPERATOR While on Models 4S3 and 5S3 (when parallel or serial is the active interface) you may see 29 LINK ERROR Ignore these messages until you have attached the printer to your computer. (Press Stop to turn off the alarm, if necessary.) 4. Press Test. Chapter 1. Setting Up the 4230 Printer 1-33