IBM 4230 User Guide - Page 38

Operator Note If you turned the power Off (O) and back On (|) in less than 10 seconds, the display may be blank or a message may appear. If the power-on messages do not appear in your language, see "Using Printer Setup Parameters" in IBM 4230 Printer Models 101, 1S2, 201, 2S2, 4S3, and 5S3 Operator Panel Instructions to change the Display Language. a. Did the printer come on after you turned the power On (|) in Step 4 on page 1-14? If Yes, go to Step 5b. If No, perform Steps 5a1 through 5a6. 1) Turn the power Off (O). 2) Unplug the printer power cord from the electrical outlet. 3) Be sure that the power cord is firmly connected to the rear of the printer. 4) Try another electrical device (such as a lamp) in the outlet. 5) If the outlet is working, connect the printer to the outlet again. Return to Step 4 on page 1-14 and try again. 6) If the printer still fails to come on, call your service representative. b. Did the printer display a code or message and did the same code or message remain on the display after approximately 30 seconds? If Yes, go to Appendix B, "Problem Solving," find the status code or message the printer displayed, and follow the instructions. If No, go to Step 5c on page 1-17. 1-16 User's Guide