IBM 4230 User Guide - Page 75
Removing the Continuous Forms Device F1
View all IBM 4230 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
Removing the Continuous Forms Device (F1) Note: If you are removing this forms device to install a different forms device, make sure you change the selected forms device in the Configuration Menu. To remove the F1 forms device, follow these steps: 1. If forms are in the printer, unload them (see "Unloading Forms" on page 1-51); then continue with Step 2 of this procedure. 2. Turn the power Off (O). 3. Open the access cover. Then open the front paper door as follows: a. Pull the door up until it will not go any higher. b. Push the door back slightly to lock it in the open position. Access C over Paper Door Chapter 1. Setting Up the 4230 Printer 1-53
Removing the Continuous Forms Device (F1)
Note:
If you are removing this forms device to install a different
forms device, make sure you change the selected forms device in
the Configuration Menu.
To remove the F1 forms device, follow these steps:
1. If forms are in the printer, unload them (see “Unloading Forms”
on page
1-51); then continue with Step 2 of this procedure.
2. Turn the power Off (O).
3. Open the access cover.
Then open the front paper door as
follows:
a. Pull the door up until it will not go any higher.
b. Push the door back slightly to lock it in the open position.
Access
C
over
Paper
D
oor
Chapter 1.
Setting Up the 4230 Printer
1-53