IBM 4840-544 Service Guide - Page 122
thumbscrew
View all IBM 4840-544 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 122 highlights
Full-size keyboard integration tray August 3, 2006 7. To remove the SurePOS 500 Models 5x3 and 544/564 from the keyboard integration tray, see Figure 72 for callout locations and perform the following steps: A B C Figure 72. Removing the SurePOS 500 Models 5x3 and 544/564 from the integration tray a. Loosen the thumbscrew on the cable tie bar and swing the cable tie bar out of the way. b. Loosen the two screws A , as shown in Figure 72. Note: When reattaching the SurePOS 500 Models 5x3 and 544/564 to the integration tray base plate, the interlocking keyholes enable you to set the SurePOS 500 Models 5x3 and 544/564 onto the two base bracket screws and lock it into a secured position until you can tighten the screws. c. Slide the SurePOS 500 Models 5x3 and 544/564 toward the rear to unlatch it from the base brackets interlocking keyholes and lift up to remove. Carefully place the SurePOS 500 Models 5x3 and 544/564 on a smooth, clean surface. 96