Netgear GS110TP GS108Tv2/GS110TP Software Reference Manual - Page 267
Hostname/IP Address, Count, Interval, Cancel, Apply, Unreachable. Tx = x
UPC - 606449069129
View all Netgear GS110TP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 267 highlights
GS108T and GS110TP Smart Switch Software Administration Manual Figure 7-8 To configure the settings and ping a host on the network: 1. In the Hostname/IP Address field, specify the IP address or the hostname of the station you want the switch to ping. The initial value is blank. This information is not retained across a power cycle. 2. Optionally, configure the following settings: • Count. Specify the number of pings to send. The valid range is 1-15. • Interval. Specify the number of seconds between pings sent. The valid range is 1-60. • Size. Specify the size of the ping (ICMP) packet to send. The valid range is 0-65507. 3. Click Cancel to cancel the operation on the screen and reset the data on the screen to the latest value of the switch. 4. Click Apply to send the ping. The switch sends the number of pings specified in the Count field, and the results are displayed below the configurable data in the Ping area. • If successful, you will see "Reply From IP/Host: icmp_seq = 0. time = xx usec. Tx = x, Rx = x Min/Max/Avg RTT = x/x/x msec." • If a reply to the ping is not received, you will see "Reply From IP/Host: Destination Unreachable. Tx = x, Rx = 0 Min/Max/Avg RTT = 0/0/0 msec". Maintenance v1.0, April 2010 7-13