Netgear GS110TP GS108Tv2/GS110TP Software Reference Manual - Page 63
Trap Configuration - v2
UPC - 606449069129
View all Netgear GS110TP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
GS108T and GS110TP Smart Switch Software Administration Manual • Status. Specify the status of this community by selecting Enable or Disable from the pull down menu. If you select Enable, the Community Name must be unique among all valid Community Names or the set request will be rejected. If you select Disable, the Community Name will become invalid. 2. To modify an existing community, select the check box next to the community, change the desired fields, and then click Apply. Configuration changes take effect immediately. 3. To delete a community, select the check box next to the community and click Delete. 4. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the latest value of the switch. Trap Configuration This page displays an entry for every active Trap Receiver. To access this page, click System SNMP SNMP V1/V2 Trap Configuration. Figure 2-15 To configure SNMP trap settings: 1. To add a host that will receive SNMP traps, enter trap configuration information in the available fields described below, and then click Add. • Recipients IP. The address in x.x.x.x format to receive SNMP traps from this device. Configuring System Information v1.0, April 2010 2-27