Yamaha M7CL M7cl V1 Owner's Manual - Page 108
Using dynamics, Dynamics graph, Level meter, DYNAMICS ON/OFF button
View all Yamaha M7CL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 108 highlights
Using dynamics Using dynamics Input channels provide two dynamics processors, and output channels provide one dynamics processor. 1 Use the navigation keys to access the OVERVIEW screen for the channel whose dynamics you want to control. The DYNAMICS 1/2 field shows the dynamics on/off status and the amount of gain reduction. • Output channels DYNAMICS 1 COMPRESSOR EXPANDER COMPANDER-H (Hard compander) COMPANDER-S (Soft compander) DYNAMICS 1 field DYNAMICS 2 field 2 In the OVERVIEW screen, press the DYNAMICS 1/2 field to access the DYNAMICS 1 (2) popup window. In the DYNAMICS 1 (2) popup window, you can edit the dynamics settings and turn the processor on/off. There are three variations of this popup window; onechannel, eight-channel, and ALL. These windows include the following items. [DYNAMICS 1 (2) popup window (1ch)] This window shows only the currently selected channel. All dynamics parameters can be viewed and edited. This is convenient when you want to make detailed dynamics settings for a specific channel. 2 3 4 1 5 9 6 7 8 1 Dynamics type buttons Use these buttons to select one of the following four types of dynamics. • Input channels 108 DYNAMICS 1 DYNAMICS 2 GATE DUCKING COMPRESSOR EXPANDER COMPRESSOR COMPANDER-H (Hard compander) COMPANDER-S (Soft compander) DE-ESSER M7CL Owner's Manual HINT • For details on the dynamics parameters, refer to the supplementary material at the end of this manual. (→ p. 225) B Dynamics graph This graph displays the approximate response of the dynamics processor. C Level meter These meters show the amount of gain reduction (GR), and the peak levels before the gate (IN) and after the gate (OUT). If the signal clips, the OVER segment will light. If the corresponding channel is stereo (a ST IN channel, a MIX/MATRIX channel set to stereo, or the STEREO channel), level meters for two channels are displayed. D DYNAMICS ON/OFF button Turns the dynamics on/off. E KEY IN CUE button (only for GATE and DUCKING) This button cue-monitors the currently selected key-in signal. HINT • Even if the Cue mode is set to MIX CUE (the mode in which all channels whose [CUE] key is on are mixed for monitoring), turning on the KEY IN CUE button will cause only the signal of the corresponding channel to be monitored. The [CUE] keys that had been turned on previously will be forcibly defeated. F THRESHOLD knob This specifies the threshold at which the dynamics will begin operating. You can use multifunction encoder 1 to control this. G Other parameters The other parameters of the dynamics processor are shown here. The parameters displayed will depend on the dynamics type that is selected. You can use multifunction encoders to adjust these parameters. HINT • For details on the parameters, refer to the supplementary material at the end of this manual. (→ p. 225)