Yamaha M7CL M7cl V1 Owner's Manual - Page 115

Using DCA groups C DCA group select buttons 1-8 These select the DCA group(s) to which the currently selected channel will be assigned. 3 Use the DCA group select buttons to select the DCA group(s) to which the currently selected channel will be assigned (multiple selections are allowed). 4 Select the DCA group(s) for other channels in the same way. Controlling DCA groups Use the faders of the Centralogic section to control DCA groups. 1 Assign input channels to DCA groups. 2 Using the faders of the top panel INPUT section or ST IN section, adjust the relative balance between the input channels belonging to the DCA group you want to use. 3 In the NAVIGATION KEYS section, press the [DCA] key to make it light so that the Centralogic section will be controlling the DCA groups. 4 Operate the Centralogic section fader corresponding to the DCA group you want to use. The level of the channels assigned to that DCA group will change while preserving the level differences you established in step 1. Grouping and linking NOTE • The input faders will not operate at this time. 5 To switch a DCA group on/off, press the 11 Centralogic section [ON] key for that DCA group. When you press a Centralogic section [ON] key to make it go dark, the channels assigned to that DCA group will be turned off (the same state as when the faders are lowered to the -∞ dB position). 6 To cue-monitor a DCA group, press the Centralogic section [CUE] key for that DCA group. When you press the Centralogic section [CUE] key to make it light, the [CUE] keys of the channels assigned to that DCA group will blink, and cue monitoring will be enabled. For more about cue, refer to "Using the Cue function" (→ p. 145). M7CL Owner's Manual 115