Yamaha M7CL M7cl V1 Owner's Manual - Page 68
Use the TO MATRIX SEND ON/OFF buttons, MATRIX sends, press the TO MATRIX SEND
![]() |
View all Yamaha M7CL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
Sending the signal from an input channel to the MATRIX buses 4 Use multifunction encoders 1-8 to adjust the send level of the signals sent from the up to eight input channels to the selected MATRIX bus. If necessary, you can use the navigation keys to switch the input channels that are assigned to the Centralogic section, and adjust the send levels from other input channels to the selected MATRIX bus. HINT • If you want to monitor the signal being sent to a specific MATRIX bus, use the navigation keys to access the corresponding MATRIX channel in the Centralogic section, and press the [CUE] key for that MATRIX channel. 5 If you want to make detailed settings for MATRIX sends, press the TO MATRIX SEND LEVEL knob inside the bold frame once again. When you press the currently selected TO MATRIX SEND LEVEL knob once again, the MATRIX SEND popup window will appear. The window includes the following items. 12 7 8 3 4 5 6 F TO MATRIX SEND LEVEL knob This screen shows the send level of the signal sent from the input channels to the MATRIX bus. To adjust the level, operate multifunction encoders 1-8. If the send-destination MATRIX bus is set to stereo, the TO MATRIX PAN knob (for a ST IN channel, the TO MATRIX BALANCE knob) and TO MATRIX SEND LEVEL knob are shown in this location. G ALL PRE button This button selects PRE as the position from which signals are sent from all input channels to VARI-type MIX buses. H ALL POST button This button selects POST as the position from which signals are sent from all input channels to VARI-type MIX buses. 6 Use the TO MATRIX SEND ON/OFF buttons to switch the signals sent from the input channels to the currently selected MATRIX bus on/off. 7 If necessary, use the PRE buttons to select the location of the signal that is sent from each input channel to a VARI type MATRIX bus. 8 Repeat steps 3-6 to adjust the send level for other MATRIX buses in the same way. 1 SEND TO This indicates the number, channel name, and icon of the MATRIX bus that is currently selected as the senddestination for signals. B ←/→ buttons Use these buttons to switch between send-destination buses. You can switch consecutively through MIX buses 1-16 and MATRIX buses 1-8. C Channel select button This indicates the channel number, the icon selected for that channel, and the channel name. When you press this button, that channel will be selected for operations, and the corresponding [SEL] key will light. D PRE button This button selects the location from which the signal of the input channel will be sent to the MATRIX bus. The signal will be sent from POST (Immediately after the [ON] key) if this button is off. The signal will be sent from the PRE EQ (Immediately before the attenuator) or PRE FADER (Immediately before the fader) as specified in the BUS SETUP popup window if this button is on. E TO MATRIX SEND ON/OFF button These are on/off switches for the signal sent from the input channels to the MATRIX bus. 68 M7CL Owner's Manual
![](/manual_guide/products/yamaha-m7cl-m7cl-v1-owners-manual-022fa08/68.png)