Yamaha M7CL M7cl V1 Owner's Manual - Page 44
Making HA (Head Amp) gain settings, Using the SELECTED CHANNEL settings for one channel
![]() |
View all Yamaha M7CL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Setting up to use the M7CL 1 In the function access area, press the SETUP button to access the SETUP screen. In the SETUP screen you can make settings that apply to the entire M7CL. 12 1 SYSTEM SETUP field B WORD CLOCK/SLOT SETUP button 2 In the SYSTEM SETUP field at the center of the window, press the WORD CLOCK/SLOT SETUP button to open the WORD CLOCK/ SLOT SETUP popup window. 1 3 In the WORD CLOCK SELECT field, select the clock source. In the WORD CLOCK SELECT field, use the buttons to select the clock source you want to use as the word clock master. ● When using clock data from a digital audio signal as the clock source Press a valid two-channel button for the corresponding slot. ● When using word clock data from the WORD CLOCK IN jack as the clock source Press the WORD CLOCK IN button. If the M7CL is operating correctly with the new clock, the symbol immediately above the corresponding button will turn light blue. HINT • The clock data of the digital audio signal supplied via a digital I/O card in slots 1-3 can be selected in two-channel units. • For details on word clock, refer to "Word Clock and Slot settings" (→ p. 208). 4 To close the WORD CLOCK/SLOT SETUP popup window, press the "×" symbol located in the upper right. You will return to the SETUP screen. 5 To close the SETUP screen, press the SETUP button in the function access area. 1 WORD CLOCK SELECT field NOTE • When you switch the word clock source, noise may occur due to loss of synchronization. Be sure to lower the volume of your power amps and monitor system before you continue with the following procedure. 44 M7CL Owner's Manual Making HA (Head Amp) gain settings Here's how to adjust the gain of the HA (Head Amp) for each input channel to which a mic or instrument is connected. On the M7CL, channel parameters can be controlled using either the SELECTED CHANNEL section to make settings for a single channel, or using the Centralogic section to make settings for up to eight channels. Use the method that's appropriate for your situation. ● Using the SELECTED CHANNEL section (settings for one channel) With this method, you select the input channel whose settings you want to adjust, and use the encoders of the SELECTED CHANNEL section to adjust the settings for that channel. 1 Make sure that a mic or instrument is connected to an INPUT jack (→ p. 39). 2 In the top panel INPUT section, press the [SEL] key for the channel corresponding to the INPUT jack you want to control. In the state immediately after scene 000 is recalled, the input signals from INPUT jacks 1-32 {1-48} are being sent to INPUT channels 1-32 {1-48} respectively, and can be controlled by corresponding channel strip.
![](/manual_guide/products/yamaha-m7cl-m7cl-v1-owners-manual-022fa08/44.png)