Yamaha M7CL M7cl V1 Owner's Manual - Page 49

3 In the Centralogic section, verify that the [ON] of the corresponding input channel is on. 4 In the STEREO/MONO MASTER section, make sure that the [ON] key of the STEREO channel is on, and raise the STEREO channel fader to 0 dB. 5 In the Centralogic section, raise the fader of the corresponding input channel to an appropriate volume. In this state, you should now hear sound from the speaker system that is patched to the STEREO channel. HINT • You can also adjust the input level using the faders of the INPUT section or ST IN section instead of the faders of the Centralogic section. If you don't hear sound, check whether the LR meters are moving in the METER field of the function access area. ● If the LR meters are moving It may be that the STEREO channel is not correctly patched to the output jacks that are connected to your speaker system. Check the output port patching (→ p. 95). ● If the LR meters are not moving It may be that the INPUT channel [ON] key is off. Check the status of the [ON] key (→ p. 16). HINT • The signal being output from the STEREO channel can also be monitored using headphones connected to the PHONES OUT jack located below the front pad (→ p. 142). 6 To adjust the pan/balance of the signal sent from each input channel to the STEREO bus, press a knob in the TO STEREO/MONO field of the screen to select it, and turn the multifunction encoders of the Centralogic section. When you turn a multifunction encoder, the knob in the TO STEREO/MONO field of the OVERVIEW screen will also turn. 7 Use the navigation keys to switch the eight channels controlled by the Centralogic section, and make adjustments for other input channels in the same way. Setting up to use the M7CL 4 Connections and setup M7CL Owner's Manual 49