Yamaha M7CL M7cl V1 Owner's Manual - Page 29

Viewing the touch screen If the oscillator or talkback is enabled, this area will indicate "OSC" or "TB" respectively. If cue monitor is on, the type of signal being cue-monitored (IN/OUT/DCA/KEY IN/EFFECT) is shown. An indication of "ACCESS" is shown while a USB storage device attached to the USB connector is being accessed. NOTE • Do not disconnect the USB connector while the "ACCESS" indication is shown here. Doing so may damage the data on the USB storage device. D Help This button is used to show on-line help in the main area. However, the current software as of September 2005 does not support this. E SENDS ON FADER Press this button to switch to SENDS ON FADER mode, where you can use the faders of the top panel to adjust the MIX send level (→ p. 64). During this time, the function access area of the touch screen will change to a screen allowing you to select the send-destination MIX bus. F CH JOB (Channel Job) Press this button to switch to CH JOB mode, where you can make settings for channel grouping and linking (→ p. 113). During this time, the function access area of the touch screen will change to a screen allowing you to select the function you want to operate. G RACK When you press this button, the VIRTUAL RACK screen will appear in the main area, allowing you to edit the GEQ or effect settings (→ p. 158). H MONITOR When you press this button, the MONITOR screen will appear in the main area, allowing you to edit the monitor or oscillator settings (→ p. 142). I METERS These are level meters that monitor the level of the STEREO bus (L/R), MONO bus (M), and cue signal (CUE). When you press this field, the METER screen will appear in the main area, displaying the meters and fader status for all channels at once (→ p. 153). J SETUP When you press this button, the SYSTEM screen will appear in the main area, allowing you to make basic system settings and user-specific settings (→ p. 207). K SCENE This indicates the number and name of the scene that was last stored or recalled. A lock icon is displayed for readonly scenes. If you edit the parameters from their last stored or recalled state, an " " symbol will appear in the lower right. When you press this field, the SCENE LIST screen will appear in the main area, allowing you to store or recall scenes (→ p. 125). When you press a button 7 through K to access the corresponding screen, the button will be highlighted. In this state, pressing the button once again will return either to the most recently recalled SELECTED CHANNEL VIEW screen or the OVERVIEW screen. Main area The contents of the main area will change depending on the function that is currently selected. Mixing operations will involve mainly the following two types of screen. ■ SELECTED CHANNEL VIEW screen This screen shows all the mix parameters for the currently selected channel. To access this screen, click one of the 3 encoders of the SELECTED CHANNEL section. Basic operation of the M7CL ■ OVERVIEW screen This screen simultaneously shows the main parameters for the (up to) eight channels currently assigned to the Centralogic section. To access this screen, press one of the keys in the NAVIGATION KEYS section or one of the multifunction encoders. HINT • If the METER screen is shown in the meter area, the OVERVIEW screen won't appear even you press a key in the NAVIGATION KEYS section. To return to the OVERVIEW screen, press a multifunction encoder or press the highlighted METER field once again. M7CL Owner's Manual 29