Yamaha M7CL M7cl V1 Owner's Manual - Page 64
Using the faders (SENDS ON FADER mode), Use the TO MIX SEND ON/OFF buttons
![]() |
View all Yamaha M7CL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
Sending the signal from an input channel to a MIX bus D PRE button This button switches the position at which the signal is sent from the input channel to a VARI type MIX bus. The signal is sent from the post-fader position when this button is off, and from the pre-fader position when this button is on. E TO MIX SEND ON/OFF button These are on/off switches for the signal sent from the input channels to the MIX bus. F TO MIX SEND LEVEL knob This screen shows the send level of the signal sent from the input channels to the MIX bus. To adjust the level, operate multifunction encoders 1-8. If the send-destination MIX bus is set to stereo, the TO MIX PAN knob (for a ST IN channel, the TO MIX BALANCE knob) and TO MIX SEND LEVEL knob are shown in this location. G ALL PRE button This button selects PRE as the position from which signals are sent from all input channels to VARI-type MIX buses. H ALL POST button This button selects POST as the position from which signals are sent from all input channels to VARI-type MIX buses. 6 Use the TO MIX SEND ON/OFF buttons to switch the signals sent from the input channels to the currently selected MIX bus on/ off. 7 If necessary, use the PRE buttons to select the location of the signal that is sent from each input channel to a VARI type MIX bus. HINT • If the PRE button is on, you can also select PRE EQ (immediately before the attenuator) or PRE FADER (immediately before the fader) for each MIX bus. This setting is made in the BUS SETUP popup window (→ p. 212). • The PRE button is not shown for FIXED type MIX buses. 8 Repeat steps 3-6 to adjust the send level for other MIX buses in the same way. Using the faders (SENDS ON FADER mode) Here's how you can use the faders of the top panel to adjust the signal that is sent from all input channels to a specific MIX bus. 1 Make sure that an output port is assigned to each MIX bus to which you want to send signals, and that your monitor system or external effect etc. is connected to the corresponding output port. For details on assigning an output port to a MIX bus refer to p. 95. For details on connecting an external device, refer to p. 39. 2 In the function access area, press the SENDS ON FADER button. The M7CL will switch to SENDS ON FADER mode. The most recently selected group of MIX buses will be assigned to the Centralogic section. The faders of the INPUT section and ST IN section will move to the send level values of each channel for the currently selected MIX bus. In SENDS ON FADER mode, the function access area in the display will show buttons for selecting the senddestination MIX bus. 1 1 MIX bus selection buttons These buttons select the send-destination MIX bus. The buttons will be joined if two MIX buses are set to stereo. 3 Use the MIX bus selection buttons in the function access area to select the senddestination MIX bus. HINT • You can also select a MIX bus by using the navigation keys and the [SEL] keys of the Centralogic section. • If you once again press the MIX button selection button that is currently selected, cue monitoring will be turned on for the corresponding MIX channel. This method is convenient when you want to monitor the signal that is being sent to the selected MIX bus. 64 M7CL Owner's Manual
![](/manual_guide/products/yamaha-m7cl-m7cl-v1-owners-manual-022fa08/64.png)