Yamaha M7CL M7cl V1 Owner's Manual - Page 109

Using dynamics H KEY IN FILTER button (only for GATE and DUCKING) This field lets you apply a filter to the key-in signal. As the filter to use, choose either a HPF (high pass filter), BPF (band pass filter), or LPF (low pass filter). If all of these buttons are off, no filter will be applied. If a filter is enabled, you can use multifunction encoders 6/7 to adjust the Q and FREQUENCY (cutoff frequency / center frequency). I KEY IN SOURCE button This displays the KEY IN SOURCE SELECT popup window, where you can select the key-in signal. [DYNAMICS 1 (2) popup window (8 ch)] This window shows the settings for eight channels, including the currently selected channel. You can switch between eight-channel groups such as 1-8 and 9-16. Compared to the one-channel display, fewer parameters can be controlled. This window is convenient when you want to adjust the threshold or certain other parameters while watching the adjacent channels to the left and the right. 1 2 3 4 5 C Dynamics graph This mini-graph displays the approximate response of the dynamics processor. D THRESHOLD knob This specifies the threshold at which the dynamics processor will begin operating. You can use multifunction encoders 1-8 to control this. E DYNAMICS ON/OFF button This turns the dynamics processor on/off. [DYNAMICS 1 (2) popup window (ALL)] This window displays the dynamics settings of all input channels (or output channels) at once. This page is only for display, and does not allow the parameters to be edited. It is useful when you need to quickly check the dynamics settings for all channels, or when you want to copy/paste dynamics settings between distant channels. 1 2 10 EQ and Dynamics 1 Channel select button This indicates the channel number, the icon selected for that channel, and the channel name. You can press these buttons to select a channel or a range of channels. B GR meter This indicates the amount of gain reduction. If you are using "GATE" as the dynamics type, an indicator showing the open/closed state of the gate is shown. Gate status indication (red) (yellow) (green) On/off status on on on off Open/closed status close open open - Gain reduction amount 30 dB or more 0-30 dB 0 dB - 1 Channel select button This indicates the channel number, the icon selected for that channel, and the channel name. You can press these buttons to select a channel or a range of channels. B GR meter This indicates the amount of gain reduction. The level display is the same as for the eight-channel window. You can press the GR meter to switch to the one-channel popup window with that channel selected. 3 Access the DYNAMICS 1 (2) popup window (1 ch), and press the DYNAMICS ON button to enable the dynamics processor. If you access the DYNAMICS 1 (2) popup window (1 ch), you'll be able to edit all parameters. M7CL Owner's Manual 109