Yamaha M7CL M7cl V1 Owner's Manual - Page 142

Using the Monitor function Using the Monitor function This section explains how to select the desired monitor source, and monitor it from the PHONES OUT jack or external monitor speakers. 1 Connect your monitor system to the rear panel OMNI OUT jacks, 2TR OUT DIGITAL jack, or an I/O card installed in a slot. The monitor signal can be sent to any desired output jack or output channel. If you're monitoring through headphones, make sure that your headphones are connected to the PHONES OUT jack under the front pad. 2 In the function access area, press the MONITOR button to access the MONITOR screen. In the MONITOR screen, the MONITOR field lets you check the current monitor settings, and turn monitoring on/off. The MONITOR screen includes the following items. 2 34 5 F OUTPUT button Turns the monitor output on/off. G PHONES LEVEL LINK button If this is on, the MONITOR LEVEL knob will adjust the level of the signal sent to the PHONES OUT jack. H MONO MONITOR button This button allows monaural monitoring. If this button is on, the signal sent from the PHONES OUT jack and the MONITOR OUT L/R channels will be monaural. 3 Press the popup button or the meter field to open the MONITOR popup window. In the MONITOR popup window you can make detailed settings for monitoring. The popup window includes the following items. 1 2 354 6 7 6 1 8 7 8 9 1 Popup button Opens the MONITOR popup window, where you can make detailed settings for monitoring. B SOURCE SELECT field Use the buttons in this field to select the monitor source. C DIMMER field The Dimmer function which temporarily attenuates the monitor signal can be switched on/off here. If you press the knob in this field so that it is enclosed by a heavy frame, you can use multifunction encoder 4 to adjust the amount of attenuation. D TALKBACK DIMMER field If Talkback is enabled, this will indicate the on/off status of the Talkback Dimmer function which automatically attenuates the monitor signal. Here you can also specify the amount of attenuation applied by the talkback dimmer. E Meter field This indicates the level of the monitor signal. This meter shows the level immediately before the dimmer. The MONITOR popup window will appear if you press this field, allowing you to make detailed settings for monitoring. 142 M7CL Owner's Manual 1 SOURCE SELECT field Use the buttons in this field to select the monitor source. This operation can also be performed using the SOURCE SELECT field in the MONITOR screen. B DIMMER field Here you can make settings for the Dimmer function which temporarily attenuates the monitor signal. • DIMMER knob ........... This adjusts the amount by which the monitor signal will be attenuated when the dimmer is on. You can use multifunction encoder 4 to control this. This operation can also be performed in the DIMMER field of the MONITOR screen. • DIMMER ON button ........... If this button is on, the monitor signal level will be attenuated according to the setting of the DIMMER knob. This operation can also be performed in the DIMMER field of the MONITOR screen.