Yamaha V4.0 DME Designer V4.0 Owners Manual - Page 144
Digital Mixers Without a [REMOTE] Connector, EtherSound Connection
![]() |
View all Yamaha V4.0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 144 highlights
Chapter 3 Main Panel Window EtherSound Connection Digital Mixers Without a [REMOTE] Connector Use an EtherSound interface card such as the MY16-ES64 to make EtherSound connections between the digital mixer and DME units. Use an Ethernet cable connected to the [NETWORK] connectors to make connections between DME series units. The port to be used for head amp control via direct serial communication with a DME unit is specified by the [Internal HA Control] parameter in the "Remote" tab in the "Utility" dialog box (page 172). Select "Slot 1" when the DME unit to be used for serial communication is a DME24N, "Slot 3" or "Slot 4" if it is a DME64N, or "EtherSound" if it is a DME Satellite unit. The settings for all other DME units should be "OFF". Use the AVS-ESMonitor software from AuviTran to specify the following EtherSound settings for both the digital mixer's interface card and the DME unit. • Serial Communication mode: Unicast for bidirectional operation. • AD8HR Remote Option: Mode 2 • Baud Rate: 38400 In order to turn serial communication off for the interface cards installed in all other DME units, set the Serial Communication mode to "Slave". EtherSound MY16-ES64 (mode 2) MY16-ES64 (mode 2) DME24N DME8i-ES Ethernet Network Switch LS9 DME4io-ES NOTE • When installing an MY16-ES64 or similar EtherSound interface card in an LS9-32, be sure to install it in SLOT 1. Also select "SLOT 1" using the COMM PORT parameter in the LS9 EXTERNAL HA display. • DME24N units with firmware version V3.04 or later are compatible. • You can download the AVS-ESMonitor software from the AuviTran website. http://www.auvitran.com/ 144 DME Designer Owner's Manual
![](/manual_guide/products/yamaha-v40-dme-designer-v40-owners-manual-50920ae/144.png)