Yamaha V4.0 DME Designer V4.0 Owners Manual - Page 289

Chapter 4 Designer Moving Line Segments To move a line segment, select the nodes on both sides of the segment, and drag one of the nodes.  Connecting to Other Wires If you drag a node and lay it over another wire, the two will be connected at that position. If you drag it to a line segment, a node will be created. Created Node Logical connection A connection from a source (output side) signal to a destination (input side) signal is called a "logical connection." If a logical connection is present in a configuration, the actual hardware signal will be connected. A single wire can make a single logical connection. Logical connections are possible only in the Configuration window and the User Module window. Wires in the Area window or Zone window can be drawn for display only. Even in the Configuration window and User Module window, you can also draw wires for display only. Window Area Window Zone Window Configuration Window User Module Window Wire Drawing for display only Drawing for display only Logical connection and drawing for display only Logical connection and drawing for display only  Situations Where No Logical Connection Is Created • Both sides are source (output side) signals • Both sides are destination (input side) signals • Two source (output side) signals are connected to a destination • There are two destination (input side) signals, and the wire is not connected to a source (output side) signal. DME Designer Owner's Manual 289