Yamaha V4.0 DME Designer V4.0 Owners Manual - Page 145
Digital Mixers With a [REMOTE] Connector, Serial Communication mode to Slave.
View all Yamaha V4.0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 145 highlights
Chapter 3 Main Panel Window Digital Mixers With a [REMOTE] Connector Connect the mixer's [REMOTE] connector to the MY16-ES64 or similar EtherSound interface card via a 9-pin D-sub cross cable, and make the appropriate EtherSound connections between the interface card and DME units. Use an Ethernet cable connected to the [NETWORK] connectors to make connections between DME series units. The port to be used for head amp control via direct serial communication with a DME unit is specified by the [Internal HA Control] parameter in the "Remote" tab in the "Utility" dialog box (page 172). Select "Slot 1" when the DME unit to be used for serial communication is a DME24N, "Slot 3" or "Slot 4" if it is a DME64N, or "EtherSound" if it is a DME Satellite unit. The settings for all other DME units should be "OFF". Use the AVS-ESMonitor software from AuviTran to specify the EtherSound serial communication settings for both the digital mixer's interface card and the interface card installed in the serially connected DME unit. • Serial Communication mode: Unicast for bidirectional operation. • Set the digital mixer's interface card to "Mode 3," and the DME unit to be used for serial communication to "Mode 2." • Baud Rate: 38400 In order to turn serial communication off for the interface cards installed in all other DME units, set the Serial Communication mode to "Slave". D-Sub 9-pin EtherSound MY16-ES64 (mode 3) MY16-EX64 MY16-ES64 (mode 2) DME24N DME8i-ES Digital Mixer DME4io-ES NOTE • DME24N units with firmware version V3.04 or later are compatible. • You can download the AVS-ESMonitor software from the AuviTran website. http://www.auvitran.com/ Ethernet Network Switch DME Designer Owner's Manual 145