Yamaha V4.0 DME Designer V4.0 Owners Manual - Page 500
MY16-C
![]() |
View all Yamaha V4.0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 500 highlights
Chapter 6 Component Guide MY16-C Right-click the block and select [Open MY-Card Editor] from the context menu to display the editor for it. MY16-C component editor Section Parameter Setting Priority Setting Priority High Sampling Input Format Mode Double FS Output Format Bundle Number Input Output Serial Channel Rx Tx Properties Bit Length Latency Setting Range Hardware/ Software DOUBLE CHANNEL/ SINGLE ON/OFF DOUBLE CHANNEL/ SINGLE 0 to 65279 0 to 65279 OFF, 1 - 16 OFF, 1 - 16 Bit Off 16 bit 20 bit 24 bit 5.33 ms 2.67 ms 1.33 ms Function The MY16-C switch settings take priority when "Hardware" is selected, and the DME Designer settings take priority when "Software" is selected. Selects the format for 88.2/96 kHz sampling rates. Linked to Output Format. When turned ON the speed of the MY card word clock output is doubled. Only available when the card is set as the word clock master. Selects the format for 88.2/96 kHz sampling rates. Linked to Input Format. Sets the input bundle number. Sets the output bundle number. Sets the serial channel for the receive side. Sets the serial channel for the send side. Sets the bit rate for output. Mutes the signal if [Bit Off] is set. Sets the delay. NOTE The parameters will not link immediately when Setting Priority is switched. Please edit another parameter after switching Setting Priority. 500 DME Designer Owner's Manual
![](/manual_guide/products/yamaha-v40-dme-designer-v40-owners-manual-50920ae/500.png)