Yamaha V4.0 DME Designer V4.0 Owners Manual - Page 324

Chapter 5 Components Changing Selections with the Key/Mouse Wheel You can modify values in selected edit boxes using the direction keys or the mouse wheel. • Up and Down Arrow Keys Increases or decreases number settings. • Key/ Key Increases or decreases number settings in large increments. The key increases and the key decreases the setting. • Key When you press the key, the numbers you entered will be confirmed. • Key + Key When you press the + key, the setting will return to its default value. • Mouse Wheel Rolling the mouse wheel upward (away from you) increases the value. Rolling it down (towards you) decreases the value. • Dragging Dragging upward increases the value, while dragging downward decreases it. • Key The key can be used to cancel a value being entered.  Graph Control Point Displays parameters graphically. When parameters are changed, the graph also changes. In graphs that have control points, you can adjust parameters by dragging the points. On graphs with control points that are limited to movement in one direction only, aligning the mouse pointer with the control point and pressing the mouse button causes the mouse pointer to change to a double-headed arrow pointing in both directions of movement. Change the parameter by dragging in the directions of the arrow. Control points that can be dragged in any direction usually have their position determined by multiple parameters in the component editor. These multiple parameters can be adjusted by dragging the point. When there are multiple control points in the graph, they are identified by their colors. A bar with the same color as each control point can be found below the corresponding knob or edit box. NOTE When a graph that has control points is copied to the User Control Editor or User Module Editor, the controls points will not be displayed. The controllers assigned to the corresponding parameters must also be copied to display the control points. 324 DME Designer Owner's Manual