Yamaha V4.0 DME Designer V4.0 Owners Manual - Page 282

Chapter 4 Designer Drawing Settings Several functions are available to help ensure accurate wire drawing.  Grid To accurately draw in relation to the grid, turn ON [Snap to Grid] in the "Grid" dialog box.  Draw Exact Vertical and Horizontal Lines When [Prohibit Diagonal Connections] in the [Tools] menu is turned ON, wires will be drawn using horizontal and vertical lines only. Diagonal wires cannot be drawn. To activate this function, select it from the menu so that a checkmark appears next to the command name in the menu. Selected the command again to remove the checkmark and deactivate the function. You can also limit wire drawing to horizontal and vertical lines by holding the key while drawing the wires. NOTE You can change the positions of existing components or nodes while converting the existing wires to wires composed only of horizontal and vertical lines by activating the [Prohibit Diagonal Connections] function. You can draw diagonal lines holding the key while dropping the objects. Wire Drawing Wire drawing starts at the positions shown in the following table: Drawing Start Location Hotspot Wire End Terminal Node Line Segment Anywhere on the Sheet Start Method Click Right-click  click [Continue Wire] on the menu Right-click  click [Start Wire] on the menu Right-click  click [Start Wire] on the menu Right-click  click [Start Wire] on the menu NOTE When creating diagrams the keyboard cursor keys can be used to move the mouse cursor, and the