Yamaha V4.0 DME Designer V4.0 Owners Manual - Page 97
Synchronization (DME Designer and Unit Synchronization), Online and Offline
View all Yamaha V4.0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
Chapter 3 Main Panel Window Synchronization (DME Designer and Unit Synchronization) The DME or SP2060 unit and DME Designer are synchronized by Synchronization. The DME or SP2060 operates according to the configuration and scene information transferred during this process. This Synchronization is used when transferring the configuration in DME Designer and when controlling the DME or SP2060 unit in real time. NOTE Because Synchronization presupposes that the DME or SP2060 unit can communicate with the computer where DME Designer is installed, the necessary drivers (USB-MIDI or DME-N Network Driver) must be installed, and appropriate settings must be made for the driver and for DME Designer communication ports (page 155). For information about driver installation and settings, see "DME Setup Manual". For DME Designer communications settings, see "Online" (page 50). NOTE Because there are no scene settings when the DME unit is purchased, the configuration and scene information in DME Designer must first be transferred. NOTE When combining DME64N/24N and DME Satellite units in a device group, be sure to assign a DME Satellite unit as the device group master. Synchronization cannot be performed if a DME64N/24N is assigned as the device group master. NOTE For information about the online procedure, see "Online" (page 50). Online and Offline When a DME or SP2060 unit is connected to the computer and synchronized with DME Designer, its status is called "Online." When a DME or SP2060 unit is not physically connected to the computer or is not synchronized even when it is connected, its status is called "Offline." You can check the online/ offline status and message transmission in [Communication Status] in the Main Panel window. Online Sends configurations created in DME Designer to the DME or SP2060 unit and reads data from the DME or SP2060 unit, so that the DME unit configuration is reflected in the DME Designer configuration. You can also control the DME or SP2060 in real time from DME Designer. Operations performed in the DME Designer control editor are reflected in the DME or SP2060 unit, and operations on the DME or SP2060 side are reflected in DME Designer. You can not perform configuration editing using the Designer while online. Offline The communication status becomes offline when editing configurations. Switching Between Online and Offline You can switch between online and offline in the "Synchronization" dialog box. NOTE For information about the online procedure, see "Online" (page 50). DME Designer Owner's Manual 97