Yamaha V4.0 DME Designer V4.0 Owners Manual - Page 521

Troubleshooting For the latest information about DME Designer, visit the Yamaha pro audio site at http://www.yamahaproaudio.com. Symptom Possible Causes Corrective Actions A compile error occurs during synchronization. DSP total resource consumption has exceeded the upper limit. Delete unneeded components. The wiring between components is Change the connections so that a single connected from multiple output terminals output is connected to a single input to a single input. terminal. Using a matrix mixer or similar component, gather multiple outputs into one signal. Cannot place component. Cannot place You are in online status. wiring. Execute [Go Off-line] on the synchronization screen to go into offline status. The Designer window in not in edit mode. Place a checkmark next to [Edit] on the [Tool] menu. The currently logged on user is restricted Logoff, then log in again as a new user, from editing. or as the Administrator. If edit restrictions are required for a user, place a check in the [Security]  [Edit] checkbox A user module is not displayed on the list. The [File] menu  [Preference]  [ContentsFolder] has been changed, or the "User Module" folder has been moved. Check that there are user module files (.umf) in the "ContentsFolder" and "User Module" folders. Cannot switch configurations in the Navigator Window. While online, you cannot not switch to a If you can switch between scenes, you configuration different from the current will be able to switch configurations. scene. The user module window does not open, This is a user module saved by selecting Open the save dialog, select [Open]  even when a user module is double- [Open]  [User Module Design [User Module Editor], and resave the clicked. Window]. user module. No editor displays after right-clicking on Some cards do not have editors. a card component, and selecting [Open] from the context menu. No special corrective action. The message "Reset Config..." is This is not abnormal. If many scenes are Wait until processing finishes. displayed for a long time in the message entered into the DME, processing takes area of the "Synchronization" dialog box. time. Cannot set the monitor output. This is because channels connected with Select an unconnected channel. wiring cannot be used as monitor output. Poor meter response. A large number of DME units displaying meters in the same device group. • Close or minimize the component editor window to reduce the dumber of DME displays. • Divide the device group containing DME units displaying meters. When the computer connection was If LAN cable connections are changed Either quit DME designer before changed the connection to the DME unit while DME Designer is running, the DME changing the LAN connections, or set was lost. units will continue to attempt to connect the Port parameter to No Assign. to the original computer. DME Designer Owner's Manual 521