Dell PowerEdge XL 5133-4 Dell PowerEdge FTOS Command Line Reference Guide for - Page 110

www.dell.com | support.dell.com ip address dhcp Acquire an IP address dynamically on an interface from the DHCP server. Syntax ip address dhcp To diable DHCP Client on an interface, use the no ip address dhcp command. Command Mode INTERFACE Default Enabled Command History Usage Information Version 8.3.17.0 Supported on M I/O Aggregator In the M I/O Aggregator, the DHCP client is enabled only on the default vlan and management interface 0/0. Use the ip address command to assign a static ip address that overwrites the dynamically assigned IP address. clear ip dhcp client statistics Displays DHCP client statistics, including the number of DHCP messages sent and received on an interface. Syntax clear ip dhcp client statistics {all | interface type slot/port} Parameters all interface type slot/ port Clear DHCP client statistics on all DHCP client-enabled interfaces on the switch. Clear DHCP client statistics on the specified interface. • For the management interface on the stack-unit, enter the keyword managementethernet followed by slot/port information. The slot and port range is 0. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. Command Mode EXEC Privilege Default None. Command History Version 8.3.17.0 Supported on M I/O Aggregator debug ip dhcp client events Enable the display of log messages for the following events on DHCP client interfaces: • IP address acquisition • IP address release • Renewal of IP address and lease time • Release of an IP address Syntax debug ip dhcp client events [interface type slot/port] 108 | Dynamic Host Configuration Protocol (DHCP)