Dell PowerEdge XL 5133-4 Dell PowerEdge FTOS Command Line Reference Guide for - Page 48

www.dell.com | support.dell.com ip telnet source-interface Set an interface's IP address as the source address in outgoing packets for Telnet sessions. Syntax ip telnet source-interface interface Parameters interface Enter the following keywords and slot/port or number information: • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For VLAN interface, enter the keyword vlan followed by a number from 1 to 4094. Defaults The IP address on the system that is closest to the Telnet address is used in the outgoing packets. Command Modes CONFIGURATION Command History Related Commands Version 8.3.17.0 Supported on M I/O Aggregator telnet Telnets to another device. line Enable and configure console and virtual terminal lines to the system. This command accesses LINE mode, where you can set the access conditions for the designated line. Syntax line {console 0 | vty number [end-number]} Parameters console 0 vty number end-number Enter the keyword console 0 to configure the console port. The console option is . Enter the keyword vty followed by a number from 0 to 9 to configure a virtual terminal line for Telnet sessions. The system supports 10 Telnet sessions. (OPTIONAL) Enter a number from 1 to 9 as the last virtual terminal line to configure. You can configure multiple lines at one time. Defaults Not configured Command Modes CONFIGURATION Command History Version 8.3.17.0 Supported on M I/O Aggregator Usage You cannot delete a terminal connection. Information Related Commands show memory View current memory usage on the M I/O Aggregator.. 46 | Control and Monitoring