Dell PowerEdge XL 5133-4 Dell PowerEdge FTOS Command Line Reference Guide for - Page 224
reset stack-unit Command Example on the Stack Standby Unit, reset stack-unit
View all Dell PowerEdge XL 5133-4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 224 highlights
www.dell.com | support.dell.com Command History Usage Information Version 8.3.17.0 Supported on M I/O Aggregator This command is used to reset the stack-unit. The master unit can also be power cycled using this command. reset stack-unit Reset any designated stack member except the management unit (master unit). Syntax reset stack-unit 0-5 hard Parameters 0-5 hard Enter the stack member unit identifier of the stack member to reset. Reset the stack unit if the unit is in a problem state. Default Command Modes Command History Usage Information none EXEC Privilege Version 8.3.17.0 Supported on M I/O Aggregator Resetting the management unit is not allowed (an error message is displayed if you try to do so). Resetting is a soft reboot, including flushing the forwarding tables. You can run this command directly on the stack standby unit (Standby Master) to reset the standby. You cannot reset any other unit from the standby unit. Example Figure 21-1. reset stack-unit Command Example on the Stack Standby Unit FTOS#show system brief Stack MAC : 00:1e:c9:f1:00:9b -- Stack Info -- Unit UnitType Status ReqTyp CurTyp Version Ports --- 0 Management online I/O-Aggregator I/O-Aggregator 8-3-17-46 56 1 Standby online I/O-Aggregator I/O-Aggregator 8-3-17-46 56 2 Member not present 3 Member not present 4 Member not present 5 Member not present FTOS# FTOS#reset stack-unit 0