Dell PowerEdge XL 5133-4 Dell PowerEdge FTOS Command Line Reference Guide for - Page 187
Layer 2, Overview, MAC Addressing Commands, Virtual LAN (VLAN) Commands
View all Dell PowerEdge XL 5133-4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 187 highlights
15 Layer 2 Overview This chapter describes commands to configure Layer 2 features. It contains the following sections: • MAC Addressing Commands • Virtual LAN (VLAN) Commands MAC Addressing Commands The following commands are related to configuring, managing, and viewing MAC addresses: • clear mac-address-table dynamic • show cam mac stack-unit Virtual LAN (VLAN) Commands The following commands configure and monitor virtual local area networks (VLANs). VLANs are a virtual interface and use many of the same commands as physical interfaces. You can configure an IP address and Layer 3 protocols on a VLAN called Inter-VLAN routing. FTP, TFTP, ACLs, and SNMP are not supported on a VLAN. Occasionally, while sending broadcast traffic over multiple Layer 3 VLANs, the virtual router redundancy protocol (VRRP) state of a VLAN interface may continually switch between Master and Backup. For more information, also refer to Virtual LAN (VLAN) Commands. Layer 2 | 185