Dell PowerEdge XL 5133-4 Dell PowerEdge FTOS Command Line Reference Guide for - Page 77
terminal monitor, traceroute
View all Dell PowerEdge XL 5133-4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
Command History Usage Information Version 8.3.17.0 Supported on M I/O Aggregator This command enables XML input mode where you can either cut and paste XML requests or enter the XML requests line-by-line. terminal monitor Configure the FTOS to display messages on the monitor/terminal. Syntax terminal monitor To return to default settings, use the no terminal monitor command. Defaults Disabled. Command Modes EXEC EXEC Privilege Command History Version 8.3.17.0 Supported on M I/O Aggregator traceroute View the packet path to a specific device. Syntax traceroute {host | ip-address} Parameters host ip-address Enter the name of device. Enter the IP address of the device in dotted decimal format. Defaults Timeout = 5 seconds; Probe count = 3; 30 hops max; 40 byte packet size; UDP port = 33434 Command Modes EXEC EXEC Privilege Command History Usage Information Version 8.3.17.0 Supported on M I/O Aggregator When you enter the traceroute command without specifying an IP address (Extended Traceroute), you are prompted for a target and source IP address, timeout in seconds (default is 5), a probe count (default is 3), minimum TTL (default is 1), maximum TTL (default is 30), and port number (default is 33434). To keep the default setting for those parameters, press the ENTER key. Control and Monitoring | 75