Dell PowerEdge XL 5133-4 Dell PowerEdge FTOS Command Line Reference Guide for - Page 142
show config INTERFACE mode, Port 0, Link Status between Port, and Port 2
View all Dell PowerEdge XL 5133-4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 142 highlights
www.dell.com | support.dell.com Figure 11-14. Display Auto-negotiation Master/Slave Setting (partial) FTOS#show interfaces configured TenGigabitEthernet 13/18 is up, line protocol is up Hardware is Dell Force10Eth, address is 00:01:e8:05:f7:fc Current address is 00:01:e8:05:f7:fc Interface index is 474791997 Internet address is 1.1.1.1/24 MTU 1554 bytes, IP MTU 1500 bytes LineSpeed 1000 Mbit, Mode full duplex, Master ARP type: ARPA, ARP Timeout 04:00:00 Last clearing of "show interfaces" counters 00:12:42 Queueing strategy: fifo Input Statistics: ... Both sides of the link must have auto-negotiation enabled or disabled for the link to come up. The following table details the possible speed and auto-negotiation combinations for a line between two 100/1000/10GB Base-T Ethernet interfaces. Table 11-3. Auto-negotiation and Link Speed Combinations Port 0 Port 1 auto-negotiation enabled* speed auto-negotiation enabled* speed 1000 or auto 1000 or auto auto-negotiation enabled speed 100 auto-negotiation enabled speed 100 auto-negotiation disabled speed auto-negotiation disabled speed 100 100 auto-negotiation disabled speed auto-negotiation enabled speed 100 100 auto-negotiation enabled* speed auto-negotiation disabled speed 1000 or auto 100 * You cannot disable auto-negotiation when the speed is set to 1000 or auto. Link Status between Port 1 and Port 2 Up at 1000 Mb/s Up at 100 Mb/s Up at 100 Mb/s Down Down Related Commands speed (for 1000/10000/auto interfaces) Set the link speed to 1000, 10000, or auto-negotiate the speed. show config (INTERFACE mode) Displays the interface configuration. Syntax show config Command Modes INTERFACE Command History Version 8.3.17.0 Supported on M I/O Aggregator 140 | Interfaces