Dell PowerEdge XL 5133-4 Dell PowerEdge FTOS Command Line Reference Guide for - Page 185

Example 1 Figure 14-1. show lacp port-channel-number Command Example FTOS#show lacp 128 Port-channel 1 admin up, oper up, mode lacp Actor System ID: Priority 32768, Address 0001.e800.a12b Partner System ID: Priority 32768, Address 0001.e801.45a5 Actor Admin Key 1, Oper Key 1, Partner Oper Key 1 LACP LAG 1 is an aggregatable link A - Active LACP, B - Passive LACP, C - Short Timeout, D - Long Timeout E - Aggregatable Link, F - Individual Link, G - IN_SYNC, H - OUT_OF_SYNC I - Collection enabled, J - Collection disabled, K - Distribution enabled L Distribution disabled, M - Partner Defaulted, N - Partner Non-defaulted, O - Receiver is in expired state, P - Receiver is not in expired state Port Te 0/1 is enabled, LACP is enabled and mode is lacp Actor Admin: State ACEHJLMP Key 1 Priority 128 Oper: State ACEGIKNP Key 1 Priority 128 Partner Admin: State BDFHJLMP Key 0 Priority 0 Oper: State BCEGIKNP Key 1 Priority 128 FTOS# Example 2 Figure 14-2. show lacp sys-id Command Example FTOS#show lacp 1 sys-id Actor System ID: Priority 32768, Address 0001.e800.a12b Partner System ID: Priority 32768, Address 0001.e801.45a5 FTOS# Example 3 Figure 14-3. show lacp counter Command Example FTOS#show lacp 1 counters LACP PDU Marker PDU Unknown Illegal Port Xmit Recv Xmit Recv Pkts Rx Pkts Rx TenGig 0/1 200 200 0 0 0 0 FTOS# Related Commands clear lacp counters show interfaces port-channel Clears the LACP counters. Displays the information on configured Port Channel groups. Link Aggregation Control Protocol (LACP) | 183