Dell PowerEdge XL 5133-4 Dell PowerEdge FTOS Command Line Reference Guide for - Page 193
protocol lldp Configuration, protocol lldp Interface, show lldp neighbors
View all Dell PowerEdge XL 5133-4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 193 highlights
protocol lldp (Configuration) Enable LLDP globally on the switch. Syntax protocol lldp To disable LLDP globally on the chassis, use the no protocol lldp command. Defaults Disabled Command Modes CONFIGURATION (conf-lldp) Command History Version 8.3.17.0 Supported on M I/O Aggregator protocol lldp (Interface) Enter the LLDP protocol in the INTERFACE mode. Syntax [no] protocol lldp To return to the global LLDP configuration mode, use the no protocol lldp command from the Interface mode. Defaults LLDP is not enabled on the interface. Command Modes INTERFACE (conf-if-interface-lldp) Command History Usage Information Version 8.3.17.0 Supported on M I/O Aggregator You must enable LLDP globally from CONFIGURATION mode before you can configure it on an interface. This command places you in LLDP mode on the interface; it does not enable the protocol. When you enter the LLDP protocol in the Interface context, it overrides global configurations. When you execute the no protocol lldp from INTERFACE mode, interfaces begin to inherit the configuration from global LLDP CONFIGURATION mode. show lldp neighbors Displays LLDP neighbor information for all interfaces or a specified interface. Syntax show lldp neighbors [interface] [detail] Parameters interface detail (OPTIONAL) Enter the following keywords and slot/port or number information: • For a 10-Gigabit Ethernet interface, enter the keyword tenGigabitEthernet followed by the slot/port information. (OPTIONAL) Enter the keyword detail to display all the TLV information, timers, and LLDP tx and rx counters. Link Layer Discovery Protocol (LLDP) | 191