Dell PowerEdge XL 5133-4 Dell PowerEdge FTOS Command Line Reference Guide for - Page 200

www.dell.com | support.dell.com source (port monitoring) Configure a port monitor source. Syntax source interface destination interface direction {rx | tx | both} To disable a monitor source, use the no source interface destination interface direction {rx | tx | both} command. Parameters interface destination direction {rx | tx | both} Enter the one of the following keywords and slot/port information: • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. Enter the keyword destination to indicate the interface destination. Enter the keyword direction followed by one of the packet directional indicators. rx: to monitor receiving packets only tx: to monitor transmitting packets only both: to monitor both transmitting and receiving packets Defaults none Command Modes MONITOR SESSION (conf-mon-sess-session-ID) Command History Example Version 8.3.17.0 Supported on M I/O Aggregator Figure 17-5. Configuring a Port Monitor Source Command Example FTOS(conf-mon-sess-11)#source tengig 10/0 destination tengig 10/47 direction rx FTOS(conf-mon-sess-11)# Usage The monitored (source) interface must be a server-facing interface in the format slot/port, where valid Information slot numbers are 0-1 and server-facing port numbers are from 1 to 32. 198 | Port Monitoring